‰  NOW 20 WPM  ‰  TEXT IS FROM FEBRUARY 2020 QST  PAGE 56‰

OF ITS MOUNT.  THE CLAMPS THAT HOLD THE BOARD ROTATE 360 DEGREES.  IF YOUR
PC BOARD IS LESS THAN 5 1/2 INCHES WIDE AND CENTERED IN THE CLAMPS, YOU CAN
ROTATE IT COMPLETELY TO WORK ON THE COMPONENT SIDE OR SOLDER SIDE AT ANY
ANGLE.  IF ITS MORE THAN 5 1/2 INCHES, YOU CAN STILL ROTATE IT BACK AND
FORTH TO GET AT BOTH SIDES.  QUADHANDS FLIP CIRCUIT BOARD HOLDER  THE
QUADHANDS CIRCUIT BOARD HOLDER SHOWN IN FIGURE 14 IS EXCEPTIONALLY RUGGED.
ITS HEFTY 2 1/2 POUND BASE, WITH NONSLIP FEET, HOLDS TWO LARGE END PIECES
WITH GROOVES TO SECURE THE PC BOARD.  IT ACCOMMODATES BOARDS AS LONG AS 12
INCHES AND AS SMALL AS A FRACTION OF AN INCH.  TO USE THIS DEVICE, LOOSEN
THE WING NUTS AT THE BOTTOM OF THE END PIECES AND THEN MOVE THEM SO THAT
THE SPACE BETWEEN THEM IS APPROXIMATELY 1/2 TO 3/4 INCH SMALLER THAN THE PC
‰  END OF 20 WPM TEXT  ‰  QST DE W1AW  ƒ