‰  NOW 25 WPM  ‰  TEXT IS FROM FEBRUARY 2017 QST  PAGE 44‰

IN JACK ON THE SPEAKER CAVITY.  ATTACH THE OTHER END OF THE CABLE TO THE
RADIO SPEAKER AUDIO OUTPUT PHONO JACK.  CONNECT THE OTHER RCA JUMPER CABLE
FROM THE CW SPEAKER AUDIO OUTPUT JACK TO THE EXTERNAL SPEAKER AUDIO IN
CONNECTION.  SET THE SPEAKER CAVITY ON THE OPERATING TABLE SO THE DISK WITH
THE 1/8 INCH HOLE IS FACING UP.  SET THE CW SPEAKER SWITCH TO THE BYPASS
POSITION THE SWITCH LEVER TO THE RIGHT.  TURN ON THE RADIO, AND SET THE
SIDE TONE OF THE RADIO TO 700 HZ.  TUNE IN A CW STATION TO WHERE THE AUDIO
IS AT 700 HZ.  SWITCH THE CW SPEAKER TO THE ON POSITION.  THE AUDIO WILL BE
VERY LOW UNTIL THE ELBOW IS INSTALLED.  PLACE THE 45 DEGREE PVC STREET
ELBOW SEE THE LEAD PHOTO ON TOP OF THE SPEAKER CAVITY SO THE NOTCHES FOR
THE SWITCH AND RCA JACK ARE LINED UP TO CLEAR THE SWITCH AND RCA PHONO
JACKS.  SLOWLY PRESS THE ELBOW DOWN OVER THE SPEAKER CAVITY AND LISTEN FOR
THE LOUDEST SIGNAL PEAK FROM THE CW SPEAKER.  MAKE SURE YOUR HAND IS NOT
‰  END OF 25 WPM TEXT  ‰  QST DE W1AW  ƒ