
After unzipping you should see eight directories here:

MISC 
                    readme.txt          - this file
                    sg_pcb.gif          - printed circuit board image
                    template.gif        - cabinet cutout template image
                    cabinet_metric.jpg  - photo with Metric units
                    cabinet.jpg         - photo in Imperial units
          
PIC16F876      
       CODE         sg11.hex     - pic code
       PIC_SOURCE   sg11.bas     - pic source code

SETUP_INTERFACE
       DISK1          - Setup Interface Install files disk 1
       DISK2          - Setup Interface Install files disk 2
       VB_SOURCE      - Setup Program VB source code files

If you are using WinZip be sure that the extract to directories option
is set, if you are using PKZIP be sure to use the -d command line option.

To install the Setup Interface Program on your PC's disk go to the 
DISK1 directory and run setup. After installation all the directories
may be safely removed (or copied to 3 1/2 inch disks). To run ensure
that Com1 is not being used by any other program as this is the default
choice then click 'Start'-'Programs'-'Spot Grabber'.

The source code directories are provided for personal educational use
only. The program does not require any of these files to run properly.
These two directories may also be safely deleted if you are not 
interested in the source code.


73
Paulo 
CT1EFL - G0MUW