Register Account

Login Help


Joined: Sat, Apr 4th 1998, 00:00 Roles: N/A Moderates: N/A

Latest Topics

Topic Created Posts Views Last Activity
Gamber Johnson Slide Mount Jul 3rd 2013, 15:09 2 5,256 on 3/7/13

Latest Posts

Topic Author Posted On
Gamber Johnson Slide Mount n0usp on 3/7/13
I recently discovered a Gamber Johnson slide mount I was using on a VHF marine radio had an intermittent antenna connection. Movement of the bracket halves apart about 2mm, although the bracket was still snapped together, opened the center RF conductor.
The RF connector is a panel mount BNC with the radio portion male, the vehicle bracket female.
I removed the male, in-line, connector from the bracket by chipping away glue with a small screwdriver, breaking the connector, and drilling out the shell. The remnants of the connector shell pushed out toward the rear of the bracket.
I purchased an in-line, male, BNC connector. The rear of the twist-lock portion of the connector was swaged over a washer. The swaged lip was easily broken with needle nose pliers allowing removal of the backing washer, spring, and locking ring from the connector shell.
I had to slightly enlarge the hole in the mount. For re-assembly thread the coax pigtail through the mount hole, front to back, trim the shield and center conductor, put the shield sleeve on the cable, solder or crimp the center pin, install the connector shell onto the cable and crimp.
Test continuity and SWR before gluing the new connector into the mount.
I used 5-minute epoxy on the rear of the new connector and cable side of the mount hole. Put the mount halves together to hold position while epoxy sets. Check excess epoxy does not glue the mount together by sliding on-off a couple of times before the epoxy sets. You will need to hold the connector cable during bracket separation. Do a final continuity/SWR check.
Gamber Johnson Slide Mount n0usp on 3/7/13
Discontinued Gamber Johnson Super Slide mobile radio mounts and repair

Back to Top


Instragram     Facebook     Twitter     YouTube     LinkedIn