ARRL

Register Account

Login Help

Forum Home - Rules - Help - Login - Forgot Password
Members can access, post and reply to the forums below. Before you do, please first read the RULES.

Tower Grounding

Mar 7th 2021, 19:45

makitaman60

Joined: Mar 6th 2021, 10:40
Total Topics: 0
Total Posts: 0
Tower height will be 40' to 50'. I would like to run a #4 copper up each leg to point just above the thrust bearing and form a small circle of #4 to tie the three runs coming off the legs. Trying to shield the rotator and thrusts bearing from any high currents from a strike by having a better more negative or positive route. I've seen this done and it works well as long the ground is equal at the top and bottom. If I can get 25 ohms or better measured at any point in the grounding system should be fine. No welded thrusts bearing a no welded rotator gears. I want that strike in the ground ASAP. Any ideas will be greatly appreciated.
Thanks
kk4byd
Tom

Back to Top

EXPLORE ARRL

Instragram     Facebook     Twitter     YouTube     LinkedIn