Register Account

Login Help

Forum Home - Rules - Help - Login - Forgot Password
Members can access, post and reply to the forums below. Before you do, please first read the RULES.

RFI from bad Netgear wall-wart switcher

May 15th 2012, 15:58


Joined: Apr 4th 1998, 00:00
Total Topics: 0
Total Posts: 0
I recently experienced a severe case of RFI that blanketed the broadcast band. It was conducted throughout the house, as I could tell when “sniffing” it with an AM radio that was held near outlets.

Coincidentally, our DSL-based Internet connection became intermittent around the same time. I did not connect the two at first. Eventually, however, while in the process of rebooting the router I noticed that its wall-wart switching power supply had become extremely hot. It was too hot to touch – clearly, not the normal operating condition.

After replacing that power supply with a spare from the junk box, the RFI vanished (and the Internet became stable again).

Hooking the bad supply to an oscilloscope revealed a sawtooth waveform on the +5 output, ramping up from 1V to 5V, then dropping and repeating the cycle. An autopsy revealed that the two main supply storage caps – 4.7uF/400V electrolytics – had swollen and leaked out their dielectric fluid. Perhaps these were some of the dreaded Bad Caps that plagued PCs a few years ago.

FWIW, the router is a NetGear RP614v4; and the power module is P/N 330 10096-1. The module is made by DVE, and is model DSA-5P-05; rated 5V/1A.



Back to Top


Instragram     Facebook     Twitter     YouTube     LinkedIn